Hotpoint Dishwasher Hose

The inlet or drain hose that carries water to and from the appliance.

Signs it has failed

• Water leaking at a tap, connector or the hose itself
• A cracked, bulging or kinked hose
• Slow filling or slow draining caused by a restriction
• A hose that no longer fits snugly to the fitting

Check before you buy

• Dry the hose and connectors, run a short cycle and look for the exact leak point
• Check the rubber washers at each end
• Check the hose is not kinked behind the appliance

What replacing it fixes: if the signs above match your dishwasher and the checks point to this part, fitting a new one should clear those faults. If the symptoms continue, the cause is elsewhere (a control board, a sensor or a blocked vent or hose).

How to replace it

1. Unplug the appliance and turn the water supply off
2. Place a tray or towels under the connection and disconnect the old hose
3. Fit the new hose with its washers and hand-tighten the nuts
4. Turn the water on slowly and check each joint for drips
5. Run a short cycle and check again

Guide steps are typical for this type of part. Layouts differ between models, so follow your own manual where it differs.

Getting the right part

Hoses vary by length, end fittings and whether they carry hot or cold water. Check the length and the connector type, and use a hose rated for the pressure and temperature.

Part numbers listed for Hotpoint dishwasher hose

These are manufacturer part numbers that a UK spares retailer lists as Hotpoint dishwasher hose parts (checked 2026-10-29). Fit is per model: a number here is a lead to check against your own rating plate, not a promise it fits your machine. Searching the exact number is the most reliable way to find the right part. The retailer lists 25 Hotpoint numbers for this part type; 10 are shown, because most fit only specific models. Search with your model number to narrow it down.

Some numbers are used across Hotpoint, Indesit, Creda and other Whirlpool-group brands. Numbers starting C00 are the Hotpoint/Indesit manufacturer reference format. If your old part has a number printed on it, match that first.

Find it on Amazon

This opens an Amazon search for the part so you see what is in stock for your model today. Look for your model number in the listing title or the “compatible models” section, and prefer sellers who state it explicitly.

Search dishwasher hose on Amazon

Other dishwasher parts