HotpointSpares
Store › USA › Dishwasher Parts › Dishwasher Dish Rack › WD12X10304
2 Pack WD12X10304 Dishwasher Upper Rack Slide End Cap Stop Clip…
Compatible

2 Pack WD12X10304 Dishwasher Upper Rack Slide End Cap Stop Clip Replacement Part by JPKTA Compatible with GE…

Part typeDishwasher Dish Rack
Made byJPKTA
Genuine or compatibleCompatible equivalent (made by another company)
Main part numberWD12X10304
Also listed asAP4484666, WD12X0344, WD12X344, WD12X10238, PS2370502, WD30X0097

View on Amazon

What it fixes

The upper, lower or cutlery basket that holds the dishes and cutlery in the dishwasher. Fit it if you see:

Will it fit your appliance?

This is a compatible equivalent made by another company, so fit depends on the model. The details below come from the seller’s own listing and are shown so you can compare them with your rating plate. Always confirm on the Amazon page before you buy.

From the seller’s listing:

Other part numbers it is listed as replacing: AP4484666, WD12X0344, WD12X344, WD12X10238, PS2370502, WD30X0097. Matching one of these to the number on your old part is the most reliable check.

Check your model number first. It is on the rating plate — usually inside the door frame, on the back or side panel, or inside the appliance. Parts that look identical often differ by model, so match the number to the listing before you order.

How to fit it

  1. Pull the basket out as far as it goes
  2. Release the stops and lift it off the runners
  3. Fit the new basket onto the runners
  4. Refit the stops and check it slides smoothly

Difficulty: Very easy. Typical time: Under 10 minutes. Read the full dishwasher dish rack guide, including checks to run before you buy.

Safety. Unplug the dishwasher and turn the water off before you start. Keep towels and a tray ready for trapped water.

Other dishwasher dish rack listings

Genuine made by Hotpoint / GE   Compatible made by another company to fit