Compatible
WE11M10001 Dryer Heating Element Replacement for GE & Hotpoint - Mica Heater Kit Also Compatible with Fisher…
| Part type | Dryer Heating Element |
|---|---|
| Made by | Qubuypro |
| Genuine or compatible | Compatible equivalent (made by another company) |
| Main part number | WE11M10001 |
What it fixes
Provides the heat that dries the clothes. Fit it if you see:
- The dryer tumbles but the air stays cold or only lukewarm
- Drying takes far longer than before
- The breaker trips when a heated cycle starts
- The element looks broken or has visibly sagging coils
Will it fit your appliance?
This is a compatible equivalent made by another company, so fit depends on the model. The details below come from the seller’s own listing and are shown so you can compare them with your rating plate. Always confirm on the Amazon page before you buy.
From the seller’s listing:
- Precise Compatibility: The GE dryer heating element WE11M10001 is engineered to seamlessly fit electric dryer models from major brands including GE, Hotpoint, Fisher & Paykel. With specifications of 240V and 5130W, it precisely matches…
- Extensive Model Compatibility: This heating element is compatible with a broad range of dryer models, including many beyond the most common ones. Please review the detailed compatibility list in the product images and description, and use…
Check your model number first. It is on the rating plate — usually inside the door frame, on the back or side panel, or inside the appliance. Parts that look identical often differ by model, so match the number to the listing before you order.
How to fit it
- Unplug the dryer and, if hard-wired, switch off its breaker
- Remove the rear or lower panel to reach the heater housing
- Photograph and disconnect the wiring
- Unscrew the element, fit the new one and replace any tripped thermostat or fuse
- Reconnect, refit the panel and test
Difficulty: Moderate. Typical time: 45 to 90 minutes. Read the full dryer heating element guide, including checks to run before you buy.
Safety. Unplug the dryer before you start (and switch off the breaker if it is hard-wired). A blocked vent is a fire risk, so always clear the cause of any overheating.
Other dryer heating element listings
Genuine made by Hotpoint / GE Compatible made by another company to fit
