Compatible
WE17X50 - ClimaTek Upgraded Dryer Drive Motor fits GE Hotpoint
| Part type | Dryer Motor |
|---|---|
| Made by | ClimaTek |
| Genuine or compatible | Compatible equivalent (made by another company) |
| Main part number | WE17X50 |
What it fixes
Turns the drum (through the belt) and drives the fan that circulates air. Fit it if you see:
- The dryer will not start, or starts and stops quickly
- A hum without the drum turning
- A burning smell or very hot motor housing
- Loud squealing or grinding from the motor
Will it fit your appliance?
This is a compatible equivalent made by another company, so fit depends on the model. The details below come from the seller’s own listing and are shown so you can compare them with your rating plate. Always confirm on the Amazon page before you buy.
From the seller’s listing:
- ▶ This ClimaTek Part Directly Replaces Part # WE17X50
Check your model number first. It is on the rating plate — usually inside the door frame, on the back or side panel, or inside the appliance. Parts that look identical often differ by model, so match the number to the listing before you order.
How to fit it
- Unplug the dryer
- Open the cabinet and remove the belt
- Disconnect the motor wiring and release the mounting bracket
- Fit the new motor and pulley, reconnect the wiring and refit the belt
- Refit the panels and run a test cycle
Difficulty: Moderate to hard. Typical time: 60 to 120 minutes. Read the full dryer motor guide, including checks to run before you buy.
Safety. Unplug the dryer before you start (and switch off the breaker if it is hard-wired). A blocked vent is a fire risk, so always clear the cause of any overheating.
Other dryer motor listings
Genuine made by Hotpoint / GE Compatible made by another company to fit
