Compatible
GSPUSA WE4X800 CKDE4X800X compatible with GE, Hotpoint Dryer Thermal Fuse fits old number WE4X800
| Part type | Dryer Thermal Fuse |
|---|---|
| Made by | GSPUSA |
| Genuine or compatible | Compatible equivalent (made by another company) |
| Model numbers named in the listing | NVLR333ET0WB, NVLR333EV0WW, BJLR473EV0WW, BVLR333EV0WW, DBLR333ET0AA, DBLR333ET0WW, DBLR333ET1AA, DBLR333ET1WW, DBLR333T0WW, DBLR453ET0AA |
What it fixes
A one-shot safety device that blows if the dryer overheats, cutting power to the heater. Fit it if you see:
- The dryer runs but there is no heat
- The dryer will not start at all on some models
- A recent history of long drying times or a hot, blocked vent
- No continuity across the fuse when tested
Will it fit your appliance?
This is a compatible equivalent made by another company, so fit depends on the model. The details below come from the seller’s own listing and are shown so you can compare them with your rating plate. Always confirm on the Amazon page before you buy.
Model numbers named in the listing: NVLR333ET0WB, NVLR333EV0WW, BJLR473EV0WW, BVLR333EV0WW, DBLR333ET0AA, DBLR333ET0WW, DBLR333ET1AA, DBLR333ET1WW, DBLR333T0WW, DBLR453ET0AA
From the seller’s listing:
- ORIGINAL CONNECTORS, New part number CKDE4X800X Perfect fit old and new serials, your old part number is no longer available, compare your old number and order now. Fit Models , NVLR333ET0WB NVLR333EV0WW BJLR473EV0WW BVLR333EV0WW…
- It is a KIT repair CKDE4X800X, ORIGINAL SPECIFICATIONS. NON OEM. The new product is made from high-quality material and OEM specifications as a generic replacement. Works with the most top name brands models DDC5000FBL DDC5000MBL…
Check your model number first. It is on the rating plate — usually inside the door frame, on the back or side panel, or inside the appliance. Parts that look identical often differ by model, so match the number to the listing before you order.
How to fit it
- Unplug the dryer
- Remove the rear or lower panel and find the fuse on the blower housing or heater box
- Pull off the two terminals and release the old fuse
- Fit the new fuse and reconnect the terminals
- Clear the vent and test the dryer
Difficulty: Easy to moderate. Typical time: 20 to 45 minutes. Read the full dryer thermal fuse guide, including checks to run before you buy.
Safety. Unplug the dryer before you start (and switch off the breaker if it is hard-wired). A blocked vent is a fire risk, so always clear the cause of any overheating.
Other dryer thermal fuse listings
Genuine made by Hotpoint / GE Compatible made by another company to fit
