Compatible
WH22X38441 for GE/Hotpoint Washer Main Electronic Control Board
| Part type | Washer Control Board |
|---|---|
| Made by | UJGFCZX |
| Genuine or compatible | Compatible equivalent (made by another company) |
| Main part number | WH22X38441 |
| Model numbers named in the listing | GTW220ACK1WW, GTW220ACK3WW, GTW220ACK4WW, GTW220ACK5WW, GTW220ACK6WW, GTW220ACK7WW, GTW330ASK0WW, GTW330ASK2WW |
What it fixes
The electronic control board (PCB) that reads the dials, buttons and sensors and switches the motor, heater, pump and valves. Fit it if you see:
- The appliance is completely dead, or the display is blank or garbled
- Buttons or the programme selector do nothing, or the cycle jumps or stops
- A fault code that keeps returning after the named part has been replaced
- Visible scorching, swollen components or a burning smell on the board
Will it fit your appliance?
This is a compatible equivalent made by another company, so fit depends on the model. The details below come from the seller’s own listing and are shown so you can compare them with your rating plate. Always confirm on the Amazon page before you buy.
Model numbers named in the listing: GTW220ACK1WW, GTW220ACK3WW, GTW220ACK4WW, GTW220ACK5WW, GTW220ACK6WW, GTW220ACK7WW, GTW330ASK0WW, GTW330ASK2WW
From the seller’s listing:
- Compatible Models:GTW220ACK1WW GTW220ACK3WW GTW220ACK4WW GTW220ACK5WW GTW220ACK6WW GTW220ACK7WW GTW330ASK0WW GTW330ASK2WW
- Please note that the part you receive may vary slightly from the photograph. For example, a part with an overlay may have a different style of buttons but will still be the same part. Parts may also have a revision noted on the part…
Check your model number first. It is on the rating plate — usually inside the door frame, on the back or side panel, or inside the appliance. Parts that look identical often differ by model, so match the number to the listing before you order.
How to fit it
- Unplug the appliance (and turn the water off if it has a water supply)
- Remove the panel to reach the board and photograph every connector and its position
- Unplug the connectors and release the board from its clips or screws
- Fit the new board with the connectors in exactly the same positions
- Refit the panel, restore power and run a short test
Difficulty: Moderate. Typical time: 30 to 60 minutes. Read the full washer control board guide, including checks to run before you buy.
Safety. Unplug the machine and turn the water off before you start. Water and electricity: keep the floor dry and never work on a live machine.
Other washer control board listings
Genuine made by Hotpoint / GE Compatible made by another company to fit
