Hotpoint Washing Machine Temperature Sensor
The thermistor or thermostat that tells the machine how hot the water is, so it can heat to the right temperature.
Signs it has failed
- The machine heats too little or too much
- A temperature-related fault code
- A wash that never leaves the heating stage
- Clothes not clean on a hot wash even though the element works
Check before you buy
- Test the element first with a multimeter
- Check the sensor wiring and connector for corrosion
- Measure the sensor resistance against the value in the manual if you have it
What replacing it fixes: if the signs above match your washing machine and the checks point to this part, fitting a new one should clear those faults. If the symptoms continue, the cause is elsewhere (a control board, a sensor or a blocked vent or hose).
How to replace it
- Unplug the machine and turn the water off
- Remove the back panel and locate the sensor on or near the heater
- Unplug the sensor and release its clip
- Fit the new sensor and reconnect
- Run a hot wash and check the cycle completes
Guide steps are typical for this type of part. Layouts differ between models, so follow your own manual where it differs.
Getting the right part
Sensors vary by resistance rating and connector. Match the part number or your model number.
Part numbers listed for Hotpoint washing machine temperature sensor
These are manufacturer part numbers that a UK spares retailer lists as Hotpoint washing machine temperature sensor parts (checked 2026-10-29). Fit is per model: a number here is a lead to check against your own rating plate, not a promise it fits your machine. Searching the exact number is the most reliable way to find the right part.
| Part number | Listed as | Retailer says it fits | |
|---|---|---|---|
| C00098739 | Hotpoint Thermostat NTC Sensor | — | Search on Amazon |
| C00014917 | Hotpoint Thermostat Grommet | — | Search on Amazon |
| C00115570 | Hotpoint One Shot Thermostat 160c | — | Search on Amazon |
| C00199324 | Hotpoint Thermostat 115c | — | Search on Amazon |
| C00508925 | Hotpoint Knob-Thermostat Gw | — | Search on Amazon |
Some numbers are used across Hotpoint, Indesit, Creda and other Whirlpool-group brands. Numbers starting C00 are the Hotpoint/Indesit manufacturer reference format. If your old part has a number printed on it, match that first.
Find it on Amazon
This opens an Amazon search for the part so you see what is in stock for your model today. Look for your model number in the listing title or the “compatible models” section, and prefer sellers who state it explicitly.
Search washing machine temperature sensor on Amazon
Other washing machine parts
Washing Machine Door Seal
The rubber gasket (also called a door boot) that seals the gap between the door glass and the drum so water stays in the machine.
Guide, symptoms & how to fitWashing Machine Drain Pump
Pumps dirty water out of the drum to the waste pipe at the end of each wash and rinse.
Guide, symptoms & how to fitWashing Machine Carbon Brushes
Carbon blocks that carry current to the spinning part of a brushed (universal) motor. They wear down with use and are designed to be replaced.
Guide, symptoms & how to fitWashing Machine Drum Bearing Kit
The bearings and seal that let the drum spin smoothly on its shaft while keeping water away from the bearings.
Guide, symptoms & how to fitWashing Machine Door Lock
The interlock that locks the door during a cycle and tells the control board it is safe to start.
Guide, symptoms & how to fitWashing Machine Shock Absorbers
The dampers (suspension) that hold the tub and absorb vibration during the spin.
Guide, symptoms & how to fitWashing Machine Water Inlet Valve
The solenoid valve that opens to let water into the machine at the right moment and closes it afterwards.
Guide, symptoms & how to fitWashing Machine Heating Element
Heats the water for hot and warm washes.
Guide, symptoms & how to fitWashing Machine Motor
The electric motor that spins the drum for washing and spinning.
Guide, symptoms & how to fitWashing Machine Drive Belt
The belt that carries the drive from the motor pulley to the drum pulley.
Guide, symptoms & how to fitWashing Machine Control Board
The electronic control board (PCB) that reads the dials, buttons and sensors and switches the motor, heater, pump and valves.
Guide, symptoms & how to fitWashing Machine Detergent Drawer
The drawer and dispenser that carry detergent and softener into the machine with the incoming water.
Guide, symptoms & how to fitWashing Machine Door Handle
The handle (or door catch) used to open and close the appliance door.
Guide, symptoms & how to fitWashing Machine Door Hinge
Holds the door on the appliance and lets it swing open and shut.
Guide, symptoms & how to fitWashing Machine Hose
The inlet or drain hose that carries water to and from the appliance.
Guide, symptoms & how to fit