Compatible
WD19X25187 Drain Pump Kit Single Speed For GE Hotpoint Monogram Dishwasher | Replaces WD19X25180 WD26X10060…
| Part type | Dishwasher Pump |
|---|---|
| Made by | FIXIT PARTS |
| Genuine or compatible | Compatible equivalent (made by another company) |
| Main part number | WD19X25187 |
| Also listed as | WD19X25180, WD26X10060, WD26X20423, WD26X20740, WD26X21254, WD26X21697, WD26X23236, WD35X10384, WD35X20553, WD35X20878, AP6993956, PS16219695, EAP16219695 |
What it fixes
Moves water around the dishwasher during the wash and pumps it out at the end. Fit it if you see:
- Water left in the bottom after a cycle
- Dishes not being washed because the spray is weak
- A loud grinding, humming or rattling from the pump
- A drain-related fault code or the cycle stopping early
Will it fit your appliance?
This is a compatible equivalent made by another company, so fit depends on the model. The details below come from the seller’s own listing and are shown so you can compare them with your rating plate. Always confirm on the Amazon page before you buy.
From the seller’s listing:
- ✅ Drain Pump Kit Single Speed, model WD19X25187, replaces PD00062506 WD19X25180 WD26X10060 WD26X20423 WD26X20740 WD26X21254 WD26X21697 WD26X23236 WD35X10384 WD35X20553 WD35X20878 4959824 AP6993956 PS16219695 EAP16219695.
- 💧 Improves Water Drainage – Replaces faulty or noisy pumps that cause water pooling or incomplete drainage at the end of a cycle.
Other part numbers it is listed as replacing: WD19X25180, WD26X10060, WD26X20423, WD26X20740, WD26X21254, WD26X21697, WD26X23236, WD35X10384, WD35X20553, WD35X20878, AP6993956, PS16219695, EAP16219695. Matching one of these to the number on your old part is the most reliable check.
Check your model number first. It is on the rating plate — usually inside the door frame, on the back or side panel, or inside the appliance. Parts that look identical often differ by model, so match the number to the listing before you order.
How to fit it
- Unplug the dishwasher and turn off the water
- Remove the lower kickboard and pull the unit out or tilt it for access
- Note the hoses and wiring, release the clamps and unplug the pump
- Remove the pump from its seal or bracket and fit the new one
- Reassemble, run a rinse and check for leaks
Difficulty: Moderate to hard. Typical time: 60 to 120 minutes. Read the full dishwasher pump guide, including checks to run before you buy.
Safety. Unplug the dishwasher and turn the water off before you start. Keep towels and a tray ready for trapped water.
Other dishwasher pump listings
Genuine made by Hotpoint / GE Compatible made by another company to fit
