HotpointSpares
Store › USA › Dishwasher Parts › Dishwasher Pump › WD26X10039
GSPUSA WD26X10039 CKDX10039X compatible with General Electric,…
Compatible

GSPUSA WD26X10039 CKDX10039X compatible with General Electric, Hotpoint, RCA, Kenmore, Dishwasher Drain Pump…

Part typeDishwasher Pump
Made byGSPUSA
Genuine or compatibleCompatible equivalent (made by another company)
Main part numberWD26X10039

View on Amazon

What it fixes

Moves water around the dishwasher during the wash and pumps it out at the end. Fit it if you see:

Will it fit your appliance?

This is a compatible equivalent made by another company, so fit depends on the model. The details below come from the seller’s own listing and are shown so you can compare them with your rating plate. Always confirm on the Amazon page before you buy.

From the seller’s listing:

Check your model number first. It is on the rating plate — usually inside the door frame, on the back or side panel, or inside the appliance. Parts that look identical often differ by model, so match the number to the listing before you order.

How to fit it

  1. Unplug the dishwasher and turn off the water
  2. Remove the lower kickboard and pull the unit out or tilt it for access
  3. Note the hoses and wiring, release the clamps and unplug the pump
  4. Remove the pump from its seal or bracket and fit the new one
  5. Reassemble, run a rinse and check for leaks

Difficulty: Moderate to hard. Typical time: 60 to 120 minutes. Read the full dishwasher pump guide, including checks to run before you buy.

Safety. Unplug the dishwasher and turn the water off before you start. Keep towels and a tray ready for trapped water.

Other dishwasher pump listings

Genuine made by Hotpoint / GE   Compatible made by another company to fit