Genuine
GE WD26X10013 Genuine OEM Pump and Motor Assembly for GE Dishwashers
| Part type | Dishwasher Pump |
|---|---|
| Made by | GE |
| Genuine or compatible | Genuine (Hotpoint / GE brand) |
| Main part number | WD26X10013 |
What it fixes
Moves water around the dishwasher during the wash and pumps it out at the end. Fit it if you see:
- Water left in the bottom after a cycle
- Dishes not being washed because the spray is weak
- A loud grinding, humming or rattling from the pump
- A drain-related fault code or the cycle stopping early
Will it fit your appliance?
This is a genuine part, which is built for the Hotpoint and GE models it is listed for. The details below come from the seller’s own listing and are shown so you can compare them with your rating plate. Always confirm on the Amazon page before you buy.
From the seller’s listing:
- Compatible with all GE (General Electric) dishwasher models produced since 1970
- High quality GE OEM manufacturing materials offer strength and durability with an exact fit design
Check your model number first. It is on the rating plate — usually inside the door frame, on the back or side panel, or inside the appliance. Parts that look identical often differ by model, so match the number to the listing before you order.
How to fit it
- Unplug the dishwasher and turn off the water
- Remove the lower kickboard and pull the unit out or tilt it for access
- Note the hoses and wiring, release the clamps and unplug the pump
- Remove the pump from its seal or bracket and fit the new one
- Reassemble, run a rinse and check for leaks
Difficulty: Moderate to hard. Typical time: 60 to 120 minutes. Read the full dishwasher pump guide, including checks to run before you buy.
Safety. Unplug the dishwasher and turn the water off before you start. Keep towels and a tray ready for trapped water.
Other dishwasher pump listings
Genuine made by Hotpoint / GE Compatible made by another company to fit
